What are the steps for DIY oil change on a Mercedes-Benz GLC 43 SUV?

Steps for DIY Oil Change on a Mercedes-Benz GLC 43 SUV

1. Prepare the necessary tools and materials:
• Oil filter wrench
• Socket set
• Oil drain pan
• New oil filter
• New oil
• Funnel
• Ramps or jack stands
• Wheel chocks
• Latex gloves
2. Ensure the car is parked on a level surface and the engine is cool.
3. Place wheel chocks behind the rear tires.
4. Use the ramps or jack stands to elevate the front of the vehicle, ensuring it is secure.
5. Locate the oil drain plug underneath the engine.
6. Position the oil drain pan beneath the drain plug.
7. Using the socket set, remove the drain plug and allow the oil to drain completely.
8. While the oil is draining, remove the old oil filter using the oil filter wrench.
9. Dispose of the old oil filter properly.
10. Apply a thin layer of oil to the rubber gasket on the new oil filter.
11. Screw on the new oil filter by hand until snug, then give it a quarter turn using the oil filter wrench.
12. Clean the oil drain plug and reinstall it, tightening with the socket set.
13. Locate the oil cap on top of the engine and remove it.
14. Using the funnel, slowly pour the new oil into the engine.
15. Refer to the vehicle's manual for the recommended oil capacity.
16. Once the desired amount of oil is added, replace the oil cap.
17. Lower the vehicle from the ramps or jack stands and remove them.
18. Start the engine and let it run for a few minutes to circulate the new oil.
19. Check the oil level using the dipstick, adding more oil if necessary.
20. Dispose of the old oil properly, either at a recycling center or your local auto parts store.

By following these steps, you can perform a DIY oil change on your Mercedes-Benz GLC 43 SUV.