Renault Symbol Oil Change Procedure

Regular oil changes are crucial for maintaining the performance and longevity of any vehicle, including the Renault Symbol. The oil change procedure for a Renault Symbol is relatively straightforward and can be done at home or by a professional mechanic. Here is a step-by-step guide on how to perform an oil change for your Renault Symbol:

Step 1: Gather the Necessary Tools and Materials

Before starting the oil change, make sure you have the following tools and materials ready:

• Wrench or socket set
• Oil filter wrench
• New oil filter
• Oil pan or container
• New engine oil (check your vehicle's manual for the recommended oil type and quantity)
• Funnel
• Rubber gloves

Step 2: Prepare the Vehicle

Park the Renault Symbol on a flat surface and engage the parking brake. Allow the engine to cool down for a few minutes.

Step 3: Locate the Oil Drain Plug

Crawl underneath the vehicle and locate the oil drain plug. It is typically located on the bottom of the engine oil pan.

Step 4: Drain the Old Oil

Place the oil pan or container beneath the oil drain plug. Loosen the drain plug using a wrench or socket set and let the old oil drain completely. Once drained, tighten the drain plug back in place.

Step 5: Replace the Oil Filter

Locate the oil filter, which is usually situated near the oil pan. Use an oil filter wrench to remove the old oil filter. Before installing the new oil filter, apply a thin layer of fresh oil to the rubber gasket on the filter. Then, screw in the new oil filter by hand until it is snug. Do not overtighten.

Step 6: Add New Oil

Locate the oil filler cap under the hood of the vehicle. Remove the cap and insert a funnel into the opening. Slowly pour the recommended amount of new engine oil into the engine, as specified in the vehicle's manual. Check the oil level using the dipstick and add more if necessary.

Step 7: Check for Leaks and Test

Double-check that the oil drain plug and oil filter are tight to prevent leaks. Start the engine and let it run for a few minutes. Inspect around the oil drain plug and filter for any signs of leakage. If no leaks are observed, turn off the engine and wait for a few minutes. Check the oil level again using the dipstick to ensure it is within the recommended range.

By following these steps, you can successfully change the oil in a Renault Symbol. However, if you are not confident in performing the procedure yourself, it is always advisable to seek assistance from a qualified mechanic.