Renault Symbol Oil Filter Location

If you own a Renault Symbol and need to change the oil filter, locating its position can sometimes be challenging. This article will guide you on where to find the oil filter in your Renault Symbol.

Step 1: Preparation

Before beginning, make sure you have all the necessary tools and equipment for the job. You will need a wrench, an oil filter wrench, a drain pan, new oil filter, and fresh engine oil. It is also recommended to park your car on a flat surface to ensure stability.

Step 2: Lifting the Vehicle

To access the oil filter, you will need to lift the vehicle using a car jack or ramps. Place the jack or ramps securely under the designated lifting points of your Renault Symbol. Carefully raise the vehicle until you have enough space to work comfortably underneath.

Step 3: Locating the Oil Filter

The oil filter in a Renault Symbol is usually located near the front of the engine, below the exhaust manifold. It is a cylindrical metal or plastic component with a screw-on cap or metal housing. The exact position may vary slightly depending on the engine model of your Renault Symbol.

Step 4: Removing the Old Oil Filter

Using an oil filter wrench, carefully loosen the cap or housing of the oil filter and unscrew it completely. Be cautious of any oil that may spill from both the filter and the engine when removing it. Place the old oil filter in a secure location to prevent any leakage or contamination.

Step 5: Installing the New Oil Filter

Take your new oil filter and apply a thin layer of fresh engine oil to the rubber gasket or seal to ensure a proper seal and prevent any leaks. Screw the new oil filter into place, ensuring it is tightened according to the manufacturer's specifications. Avoid over-tightening as it may damage the filter or housing.

Step 6: Lowering the Vehicle and Adding New Oil

Once the new oil filter is securely in place, carefully lower the vehicle back to the ground using the car jack or ramps. Remove the jack or ramps, and locate the oil filler cap on the top of the engine. Open it and pour in the recommended amount of fresh engine oil, according to your vehicle's specifications.

Step 7: Checking for Leaks

After adding new oil, start your Renault Symbol and let it run for a few minutes. Check underneath the vehicle for any signs of oil leakage around the oil filter. If no leaks are detected, turn off the engine and close the hood.

Conclusion

Changing the oil filter in your Renault Symbol is an essential part of routine vehicle maintenance. By following the steps outlined in this article, you will be able to locate and replace the oil filter with ease. Remember to consult your vehicle's manual and follow the manufacturer's recommendations for oil type, filter, and maintenance intervals to ensure optimal performance and longevity of your Renault Symbol.