Resolving F20 Error Code Related to Water Level Sensors on Maytag Washer

A common issue that many Maytag washer users may encounter is the F20 error code, which is typically associated with problems related to the water level sensors. This error code indicates that the washer is not getting enough water or is experiencing issues while detecting the water level during a wash cycle.

Thankfully, resolving this F20 error code is usually a straightforward process that you can easily handle yourself. By following some troubleshooting steps, you can often fix the error and get your Maytag washer back up and running smoothly. Here are some simple steps to help you resolve the F20 error code:

1. Check Water Supply

Ensure that there is an adequate water supply to the washer. Make sure the water valves are fully open and that the water supply hoses are not kinked, twisted, or clogged. It is also important to note that some washers require both hot and cold water to function properly, so check if both hot and cold water supply is available.

2. Clean Water Inlet Screens

The water inlet screens of the washer can sometimes become clogged with debris, limiting the flow of water and triggering the F20 error code. To clean these screens, turn off the water supply and disconnect the hoses from the washer's back. Check for any dirt or debris in the screens and gently clean them using a soft brush or a toothbrush. Once cleaned, reconnect the hoses and turn on the water supply again.

3. Inspect Water Level Sensor or Pressure Switch

The water level sensor, also known as the pressure switch, is responsible for detecting the water level in the washer. If this sensor becomes faulty or is clogged, it may lead to the F20 error code. Inspect the water level sensor and ensure it is clean and free of any debris. Gently blow into the sensor tube to clear any obstructions. If the problem persists, the water level sensor may need to be replaced.

4. Check Drainage System

A malfunctioning drainage system can also cause the F20 error code on your Maytag washer. Ensure that the drain hose is not clogged or kinked and that it is properly connected to the drain pipe or standpipe. Additionally, make sure that the drain hose is not submerged in water, as this can prevent proper drainage.

5. Reset the Control Panel

If none of the above steps resolve the F20 error code, try resetting the control panel of your Maytag washer. Unplug the washer from the power source for approximately one minute, then plug it back in. This process can often clear any minor glitches or errors in the washer's system.

By following these troubleshooting steps, you should be able to resolve the F20 error code related to water level sensors on your Maytag washer. However, if the issue persists or if you are unsure of performing these tasks yourself, it is always recommended to consult a professional technician or contact Maytag customer support for further assistance.