Subaru BRZ Oil Change DIY

Introduction

Regularly changing the oil in your Subaru BRZ is essential for maintaining the health and performance of your vehicle's engine. While taking your car to a mechanic for an oil change is an option, doing it yourself can save you time and money. In this article, we will guide you through the process of changing the oil in your Subaru BRZ, giving you the satisfaction of taking control of your vehicle's maintenance.

Things You'll Need

• Oil filter wrench
• Drain pan
• Socket wrench set
• Oil filter
• New oil
• Funnel

Step-by-Step Instructions

Step 1: Prepare

Park your Subaru BRZ on a flat surface and engage the parking brake. Ensure that the engine has cooled down to prevent any potential burns during the oil change process.

Step 2: Locate the Oil Drain Plug and Oil Filter

The oil drain plug is typically located underneath the car's engine. Use the socket wrench set to loosen and remove the drain plug, allowing the old oil to drain into the drain pan. Locate the oil filter, which is generally at the front or side of the engine. Use the oil filter wrench to carefully remove the old oil filter.

Step 3: Replace the Oil Filter

Before installing the new oil filter, apply a small amount of new oil to the rubber gasket on its exterior. This will ensure a proper seal and easier removal during the next oil change. Carefully screw the new oil filter into place, ensuring it is snug but not overly tight.

Step 4: Drain the Old Oil Completely

After allowing enough time for the old oil to drain, clean the drain plug and reinstall it securely. Ensure that it is tightened to prevent oil leaks. Dispose of the old oil properly by taking it to a recycling center or a designated oil collection point.

Step 5: Add New Oil

Locate the oil cap on top of the engine and remove it. Using a funnel, pour the recommended amount and type of new oil into the engine. Refer to your vehicle's owner manual for the specific oil type and quantity. Reinstall the oil cap tightly.

Step 6: Check for Leaks

Once you have finished adding the new oil, start the engine and let it run for a few minutes. Check underneath the car for any signs of oil leaks. If you notice any leaks, stop the engine immediately and check the oil filter and drain plug for proper installation.

Step 7: Clean Up

Properly dispose of the old oil, clean any spills, and recheck the oil level using the dipstick. Take your Subaru BRZ for a short test drive to ensure everything is functioning properly. Congratulations, you have successfully completed an oil change on your Subaru BRZ!

Conclusion

Performing regular oil changes is a crucial part of maintaining your Subaru BRZ's engine in top condition. By following these step-by-step instructions, you can confidently perform a DIY oil change, saving time and money while keeping your vehicle performing at its best.