Yardmax Dual Rotating Rear Tine Tiller YT4565 Troubleshooting
Problem
Engine fails to start.
Cause
1. Spark plug wire is disconnected
2. Out of fuel or stale fuel
3. Engine and/or Fuel valve is not in
ON position
4. Choke lever is not in CLOSE position
5. Blocked fuel line
6. Fouled spark plug
7. Engine flooding
8. Belt tension lever is engaged
Remedy1. Foreign object lodged in tines.
2. Tine clevis pin(s) missing.
3. B elt worn and/or stretched.
4. Pulley and idler not in correct
adjustment.
1. Attach spark plug wire securely to spark plug
2. Fill with clean, fresh gasoline
3. Engine and Fuel valve must be in ON position
4. Choke level must be in CLOSE position for a cold start
5. Clean fuel line
6. Clean, adjust gap, or replace
7. Wait a few minutes to restart, but do not prime
8. Disengage the belt tension lever
Problem
Engine runs erratically
Cause
1. Spark plug wire is loose
2. Unit running with Choke lever in
CLOSE position
3. Blocked fuel line or stale fuel
4. Vent plugged
5. Water or dirt in fuel system
6. Dirty air cleaner
7. Improper carburetor adjustment
Remedy
1. Connect and tighten spark plug wire
2. Move choke lever to OPEN position
3. Clean fuel line. Fill tank with clean, fresh gasoline
4. Clear vent
5. Drain fuel tank. Refill with fresh fuel
6. Clean or replace air cleaner
7. Refer to engine manual
Problem
Engine overheats
Cause
1. Engine oil level low
2. Dirty air cleaner
3. Air flow restricted
4. Carburetor not adjusted properly
Remedy
1. Fill crankcase with proper oil
2. Clean air cleaner
3. Remove housing and clean
4. Refer to engine manual
Problem
Engine will not stop when throttle control is positioned at stop, or engine speed does not increase properly when throttle control is adjusted.
Cause
1. Debris interfering with throttle linkage.
2. Improper throttle linkage adjustment
Remedy
1. Clean dirt and debris.
2. Refer to Engine Manual to check and adjust throttle linkage.
Problem
Tiller moves forward during starting.
Cause
Tine clutch control not in neutral position.
Remedy
Tine clutch control lever must be released to neutral to start the engine.
Problem
Tiller is difficult to control when tilling (machine jumps or lurches forward).
Cause
1. Improper tilling depth setting.
2. Too high engine speed on hard ground.
Remedy
1. Raise the tines for shallower tilling by raising the depth regulator rod.
2. Set the throttle lever at lower speed.
Problem
Tines do not engage.
Cause
1. Foreign object lodged in tines.
2. Tine clevis pin(s) missing.
3. B elt worn and/or stretched.
4. Pulley and idler not in correct adjustment.
Remedy
1. Stop tiller completely, check and discard foreign object.
2. Replace tine clevis pin(s).
3. Replace belt.
4. Contact dealer.
Published: Tuesday, July 16, 2019 ViewedAsk me about:
Askme / 7/16/2019 7:03:18 AM (Original: 1000X1000 px)
Askme / 7/16/2019 7:03:40 AM (Original: 768X768 px)
Askme / 7/16/2019 7:03:56 AM (Original: 750X422 px)
I noticed that on planes, especially during take-off and landing, the stewardesses check them one by one and if the curtains are closed on the window, they open them. Does anyone know why?
Plane / curtain Answers: 0Earning $2,000 daily with a Facebook Page requires a combination of strategic planning, engaging content, and effective monetization methods.
Make money / Earning $2,000 daily with a Facebook Answers: 5What are the pros and cons of selling my home fast for cash?
Home / Selling Answers: 5What are the top-selling toys for kids in America right now? Which toys are currently trending in America? What's the most sought-after toy among American children?
Toys / Popular toy in America Answers: 3Why won't my 1986 Suzuki Intruder VS 700 shift gears when it is running? What are the possible causes of this issue, and what steps can I take to troubleshoot and fix it?
Suzuki / Intruder Answers: 3How can I set the time on a Fanmis sport watch/pedometer that I purchased in August?
Watch / Fanmis sport watc Answers: 5How can I set the date, time, and seconds for Naviforce for Dream NF9153M watch?
Watch / Dream NF9153M Answers: 5What can I do if the analog hands of my 5.11 HRT Titanium watch are not moving even after I have replaced the coin lithium battery and the digital functions are working?
watch / 5.11 HRT Titanium Answers: 5What are the steps to program frequency 8113.5 on a Furuno FSS1503 Single Sideband Radio Telephone?
Furuno / Single Sideband Answers: 5Where can I find the light fuse on a 1995 Lowe boat with a 30 hp Evinrude motor?
Lowe / boat Answers: 5What could be the reason for an AOSmith 1hp lift motor to start and then trip the breaker?
AOSmith / 1hp lift motor Answers: 5Does the 600 ACE ET Ski-Doo have a drain valve for coolant?
Ski-Doo / 600 ACE ET Answers: 5How can I change the MMSI on a FA-170 AIS if I am far away from a Furuno dealer?
Boating / FA-170 AIS Answers: 5What is the USA Collection Friendship Lamp?
Lamp / Collection Friendship Answers: 5What are some of the best boat maintenance apps available?
Boat / maintainence apps Answers: 3