How do I fix C2 error code on dishwasher?

The C2 error code on a GE dishwasher typically indicates a problem with the drain system. Here are some steps you can take to try and fix the C2 error code:

1. Check the Drain Hose: Ensure that the drain hose is properly connected and not kinked or clogged. Make sure it is securely attached to the dishwasher and that the other end is properly connected to the drain or garbage disposal.
2. Clear any Blockages: If you suspect a blockage in the drain hose or garbage disposal, remove any debris or obstructions that may be causing the clog. You can use a plumber's snake or a wire hanger to clear any blockages.
3. Clean the Filter: Locate and remove the dishwasher filter. Clean it thoroughly under running water to remove any food particles or debris that may be blocking the drain.
4. Check the Drain Pump: The C2 error code can also be triggered by a malfunctioning drain pump. To check the pump, you may need to access the bottom of the dishwasher. Disconnect the dishwasher from the power source and inspect the drain pump for any visible signs of damage or blockage. If necessary, clean or replace the drain pump.
5. Reset the Dishwasher: After performing the above steps, reset the dishwasher by turning off the power at the circuit breaker or unplugging it for a few minutes. Then, restore power and run a test cycle to see if the error code persists.

If the C2 error code persists even after attempting these troubleshooting steps, it may be best to contact a professional appliance repair technician or GE customer service for further assistance. They will have the expertise and specific knowledge to diagnose and fix the issue with your GE dishwasher.

Location: Des Moines, IA?