Engine Oil and Filter Change: Mitsubishi Attrage

Regular maintenance is essential to ensure the smooth and efficient performance of your Mitsubishi Attrage. One crucial maintenance task is changing the engine oil and filter at recommended intervals. This article will guide you through the process of changing the engine oil and filter in your Mitsubishi Attrage.

Step 1: Gather the Required Tools and Materials

Before you start, make sure you have the necessary tools and materials. These include:

• Oil filter wrench
• Socket wrench set
• New engine oil filter
• Correct type and amount of new engine oil (refer to your vehicle's manual for specifications)
• Oil drain pan
• Rubber gloves
• Shop towels

Step 2: Prepare Your Vehicle

Start by parking your Mitsubishi Attrage on a flat surface and engaging the parking brake. Ensure that the engine has completely cooled down before proceeding.

Step 3: Drain the Old Oil

Locate the oil drain plug underneath the vehicle's engine. Use a socket wrench to loosen and remove the drain plug. Place the oil drain pan underneath to catch the old oil. Allow all the old oil to drain out completely.

Step 4: Replace the Oil Filter

Locate the oil filter, which is usually located near the engine block. Use an oil filter wrench to loosen and remove the old oil filter. Make sure to have the drain pan beneath it as well to catch any remaining oil. Once removed, dispose of the old filter properly. Take the new oil filter, lubricate its rubber gasket with a bit of new oil, and screw it into place by hand until snug. Don't overtighten it.

Step 5: Refill with New Oil

After the old oil has drained completely and the new filter is in place, it's time to refill the engine with fresh oil. Refer to your vehicle's manual to determine the correct type and amount of oil needed. Slowly pour the new oil into the oil filler cap, using a funnel to avoid any spills. Once filled, replace the oil filler cap securely.

Step 6: Check Oil Level and Clean Up

Start your engine and let it idle for a few minutes. Turn off the engine and wait a few additional minutes for the oil to settle. Check the oil level using the dipstick. If needed, add more oil to reach the recommended level. Finally, clean up any spilled oil using shop towels and dispose of them properly.

Step 7: Properly Dispose of Old Oil and Filter

It's important to dispose of the old oil and filter responsibly. Many auto parts stores or service centers accept used oil and filters for recycling. Do not dump them in the trash or pour them down drains, as it can cause environmental contamination.

Following these steps will help you maintain the performance and longevity of your Mitsubishi Attrage. Regular oil and filter changes ensure that your engine stays well-lubricated, providing optimal efficiency and reducing the risk of engine damage. Always refer to your vehicle's manual for specific instructions and consult a professional if you are unsure about any aspects of the process.