What is a chaise chair? How to make a patio chair? What size is a love seat? How long is a loveseat?

How to Build a Patio Chair
Measure and mark Increments on both ends and one side of the hardboard. Then draw grid lines using a combination square, straightedge and fine-point permanent marker.
Develop the pattern Transfer the points to your hardboard grid where the shape intersects the grid lines in the drawing.
Draw the lines Draw lines connecting the points made on the grid. Use a smooth, arcing arm movement to draw the gradual curve. Use a quarter to trace the 1/2-in. radiuses at the bottom of the leg. Use a jigsaw to cut out the pattern.
Align the backrest Align the backrest strut template to the centerline and bottom edge of the cedar piece and trace the shape. Flip the template along the centerline to draw the other half. Cut out the pieces with a jigsaw.
Sand the edges Sand the edges of the curved pieces with a belt sander. If you dont have a bench vise, you can support the legs with a handscrew clamp while you sand.
Cut all the pieces to the dimensions given in the Cutting List, using the templates for the legs and the top slat. Cut out the shapes with a jigsaw, then sand the pieces with a belt sander.
Drill the ends:
Drill the ends of the hand grip holes with a 1-in. dia. spade bit. Drill partway in from both sides so you wont tear out the wood.
Align the seat: Use a carpenters square to align the seat supports 90 degrees to the backrest struts, then glue and screw them in place. Use both glue and screws to attach the slats, too.
Attach the slats:
Attach the slats to the seat struts using a 1/2-in. thick spacer to align them. Finish driving the screws by hand to avoid setting their heads too deep.
Finishing Touches
Before applying the finish, unscrew the two seat supports and apply weather-resistant glue (like Titebond II or Gorilla Glue) to the joints, then rescrew the seat supports to the backrest struts. The glue will strengthen the joint. The chair relies primarily on these seat supports for strength.

What size is a love seat?
A standard love seat is approximately 64 inches wide, 36 inches high and 38 inches deep. While there is no standard template for a love seat's size, the dimensions do tend to fall within a narrow range. A love seat is a smaller size sofa intended to seat just two people.

How long is a loveseat?
While loveseat dimensions vary, most loveseats are four to six feet long (measured arm to arm) and about 37 inches deep however, the dimensions of a loveseat differ according to style and shape. There are many dimensions that affect a loveseat's appearance and fit in a room.

I found the article to be enjoyable 🍄🐇

Persuasive 😊🙌

.. thanks✋