How to reset self-diagnosis feature on Whirlpool washer?

How to Reset the Self-Diagnosis Feature on Whirlpool Washer - Step-by-Step Guide

How to Reset the Self-Diagnosis Feature on Whirlpool Washer

Whirlpool washers come equipped with a self-diagnosis feature that helps identify and troubleshoot various issues. However, there may be instances where you need to reset this feature to clear any stored error codes and start fresh. In this step-by-step guide, we will walk you through the process of resetting the self-diagnosis feature on your Whirlpool washer.

Step 1: Turn off the Washer

Before resetting the self-diagnosis feature, ensure that the washer is turned off. Press the Power button on the control panel or unplug the washer from the power source.

Step 2: Wait for a Few Minutes

Allow the washer to remain unplugged or turned off for at least five minutes. This time will enable the washer's internal components to fully reset and clear any stored error codes.

Step 3: Plug the Washer Back In or Turn It On

After waiting for a few minutes, plug the washer back into the power source or turn it on using the Power button. Ensure that the washer is properly connected to a grounded power outlet.

Step 4: Access the Diagnostic Mode

To access the diagnostic mode on your Whirlpool washer, follow these steps:

• 1. Make sure the washer is in standby mode (plugged in with all indicators off).
• 2. Press and hold the "Start" button.
• 3. While holding the "Start" button, simultaneously rotate the control knob clockwise by one click (to the right) and then counterclockwise by one click (to the left).
• 4. Repeat the clockwise and counterclockwise rotation of the control knob three more times within 8 seconds.
• 5. The washer should now enter the diagnostic mode, indicated by all the indicator lights turning on.

Step 5: Reset the Self-Diagnosis Feature

Once you have successfully entered the diagnostic mode, follow these steps to reset the self-diagnosis feature:

• 1. Press the "Start" button to initiate the automatic test mode.
• 2. Allow the test cycle to run completely until it reaches the end. This might take several minutes.
• 3. Once the test cycle is finished, the self-diagnosis feature is reset, and the washer will return to the standby mode.

Step 6: Verify the Reset

To confirm that the self-diagnosis feature has been successfully reset, check if any error codes are displayed on the control panel. If no error codes are present, the reset process was successful.

Conclusion

Resetting the self-diagnosis feature on your Whirlpool washer is a straightforward process that can help in resolving various error codes and issues. By following the step-by-step guide outlined above, you can easily reset the self-diagnosis feature and start fresh with your washer.