What are solutions to Asko washer error codes?

Solutions to Asko Washer Error Codes

Asko washers are known for their durability and quality performance. However, like any other appliance, they can occasionally encounter issues and display error codes on the control panel. These error codes serve as a diagnostic tool and indicate specific problems within the machine. Understanding and troubleshooting these error codes can help you fix the issues without the need for professional assistance. In this article, we will discuss the common Asko washer error codes and their solutions.

Error Code E10

The E10 error code on your Asko washer indicates a water inlet issue. To resolve this error:

1. Check if the water supply valves are fully open.
2. Inspect the inlet hoses for any kinks or obstructions. Straighten or replace them if necessary.
3. Ensure that the water pressure is adequate. Insufficient pressure may prevent the washer from filling properly with water.
4. Clean the inlet filters to remove any debris that might be blocking the water flow.

Error Code E20

Error code E20 suggests a drainage problem. These are the steps to rectify it:

1. Check the drain hose for any clogs or kinks. Straighten or clear any obstructions.
2. Inspect the drain pump for blockages. Clean or replace the pump if required.
3. Make sure the drain filter is clean. A dirty filter can impede water flow and cause drainage issues.
4. Verify that the drain hose is properly connected to the sewer line or drainage system.

Error Code E30

An E30 error code indicates a motor problem in your Asko washer. Follow these steps to troubleshoot it:

1. Ensure the washer is not overloaded with laundry. Overloading can strain the motor.
2. Check for any loose or damaged electrical connections to the motor. Tighten or repair them as needed.
3. Examine the motor brushes for wear. Worn-out motor brushes may need replacement.
4. If the above steps do not resolve the error, it is recommended to contact a professional technician.

Error Code E40

The E40 error code indicates a door lock problem. To address this issue:

1. Ensure the door is tightly closed and latched properly.
2. Check the door lock mechanism for any obstructions or damage. Replace if necessary.
3. Inspect the door lock switch and wiring for any faults. Repair or replace them if needed.
4. If the error persists, it is advisable to seek professional assistance.

Error Code EFO

Error code EFO points to a drain filter problem. Try these solutions to fix it:

1. Clean the drain filter thoroughly. A clogged filter can hinder proper water flow.
2. Ensure that the drain hose is not bent or obstructed. Straighten or clear any blockages.
3. Check the drain pump for any debris or damage. Replace or repair the pump if required.
4. If the error code continues to appear, consult a professional technician for further assistance.

Remember to always disconnect the power supply before attempting any troubleshooting or repairs on your Asko washer. If you are unsure about handling a particular error code, it is best to contact Asko customer support or a qualified technician for guidance.

By following the solutions mentioned above, you can often resolve common error codes on your Asko washer and get back to enjoying its efficient performance in no time.