How to reset E01 F03 code on Whirlpool washer?

How to Reset E01 F03 Code on Whirlpool Washer?

If you own a Whirlpool washer and see the error codes E01 and F03 displayed on the control panel, it means that a significant issue has been detected. These codes indicate a problem with the washer's drain pump or the pressure switch, which are vital components in maintaining proper water flow and drainage. Luckily, there are several steps you can take to reset the E01 F03 code and potentially resolve the issue.

1. Verify the Error Code

Before proceeding with any troubleshooting, ensure that the E01 F03 code is indeed being displayed. Confirm that it corresponds to the drain pump or pressure switch problem. This will help you identify the exact issue and take appropriate action.

2. Turn Off and Unplug the Washer

The first step in attempting to reset the error code is to turn off the washer and unplug it from the power source. This precautionary measure ensures your safety during the troubleshooting process and allows the washer's internal systems to reset.

3. Check for Clogs

Once the washer is disconnected from power, inspect the drain hose and the drain pump filter for any obstructions. Clogs or debris may prevent proper water drainage, leading to the error code. Clear any blockages you find and ensure the drain hose is not kinked or damaged.

4. Test the Pressure Switch

The pressure switch is responsible for monitoring the water level in the washer. If it malfunctions, it can trigger error codes like E01 F03. To test the pressure switch, you will need a multimeter. Carefully follow the manufacturer's instructions to check the switch's continuity and compare the readings to the specified range. If the pressure switch is faulty, replacing it might resolve the error.

5. Inspect the Drain Pump

A malfunctioning drain pump can also cause the E01 F03 error code. Carefully remove the access panel at the front or back of the washer to locate the pump. Ensure there are no blockages within the pump causing it to fail. Additionally, check the pump for any signs of damage or wear. If necessary, clean or replace the drain pump to resolve the issue.

6. Reset the Control Panel

Once you have inspected and resolved any potential issues with the drain pump and pressure switch, it's time to reset the control panel. Plug the washer back into the power source and turn it on. Press and hold the "Cancel" or "Start" button for a few seconds until the washer's control panel resets. This action should clear the error code from the display.

7. Run a Test Cycle

To ensure that the error code has been successfully reset and the washer is operating correctly, run a test cycle. Select a small load setting, add some laundry, and start the cycle. Observe the washer's performance throughout the cycle and verify that it completes without displaying any further error codes.

Following the steps mentioned above should help you reset the E01 F03 code on your Whirlpool washer. However, if the error code persists or you are unsure about performing certain troubleshooting steps, it is recommended to contact a professional technician or the Whirlpool customer support team for further assistance.