How to replace Redmi Note 4G battery?

How to Replace Redmi Note 4G Battery - Step-by-Step Guide

How to Replace Redmi Note 4G Battery: Step-by-Step Guide

Is your Redmi Note 4G battery no longer holding a charge like it used to? Are you experiencing frequent shutdowns or rapid battery drain? It might be time to replace the battery of your Redmi Note 4G. Don't worry, replacing the battery is quite a straightforward process. In this article, we will guide you through the step-by-step process of replacing the battery in your Redmi Note 4G.

Step 1: Gather the Necessary Tools

Before you begin, make sure you have the following tools:

• Philips screwdriver: To remove the screws holding the back cover.
• Plastic pry tool or guitar pick: To gently pry open the back cover.
• New battery: Purchase a compatible replacement battery for your Redmi Note 4G.

Step 2: Power Off Your Device

Ensure your Redmi Note 4G is turned off before proceeding with the battery replacement. This prevents any potential damage to the device or the battery.

Step 3: Remove the Back Cover

Using the Philips screwdriver, carefully remove the screws holding the back cover in place. Once the screws are removed, gently insert the plastic pry tool or guitar pick between the back cover and the device. Slowly and carefully pry open the back cover, starting from one corner and working your way around. Be cautious not to apply too much force, as it may damage the plastic.

Step 4: Remove the Old Battery

Locate the battery inside your Redmi Note 4G. It usually sits near the bottom of the phone. Disconnect any connectors or cables attaching the battery to the device using a pair of tweezers or a spudger tool. Once disconnected, gently lift the battery from its position. Take note of how the battery is placed, as you will need to install the new battery in the same orientation.

Step 5: Install the New Battery

Take the new battery and carefully position it into the empty battery compartment, aligning it with the connectors. Gently press the battery down until it securely fits into place. Ensure it is properly aligned and positioned.

Step 6: Reattach the Back Cover

Line up the back cover with the phone and gently press it down. Make sure it snaps into place and is flush with the edges of the device. Inset and tighten the screws using the Philips screwdriver.

Step 7: Power On and Test

Now that the battery has been replaced, power on your Redmi Note 4G and check if it is functioning properly. Fully charge the new battery and ensure it holds a charge for an adequate amount of time.

Congratulations! You have successfully replaced the battery in your Redmi Note 4G. Enjoy the improved battery performance and extended usage time.

Note: If you are unsure about any of the steps or uncomfortable performing the battery replacement yourself, it is recommended to seek professional assistance or contact the Redmi customer support for further guidance.